Search the Community
Showing results for tags 'dynamic simulation'.
Found 4 results
Hello there to Everyone , i'm trying to create a dynamic Simulation scrpt , but to be honest , i don't know really if the current is working or not ! I 'm not also sure about dynamicSimulationSystem generally , because i haven't seen this working on another script either ! My try below for everyone : - deleted any help will be much appreciated ! Thank you very much !!! _______________________________________________________________________________________________________________ the solution :
As from topic, I was thinking that they are almost the same but, after a little bit of testing, it seems they work in pretty different ways: - Dynamic simulation stops the simulation of units at a given distance from the player without despawning them, leaving them "freezed" until the distance with the player doesn't fall under the give threshold; - The Simulation management module doesn't only stops simulation, but it seems to despawn units until the player reduces the distance to the given threshold; when this happens units respawn exactly where they was, in the same position, and the simulation restarts normally. I'm not sure but it seems that, to enable this behaviour, you don't need to flag the same voice in the unit attributes that enables the dynamic simulation. Am I correct? I've also noticed peculiar interaction between those two features: if Dynamic simulation threshold is smaller than the Simulation manager module, it seems that - since units should spawn when simulation is stopped, they cannot spawn anymore; in the opposite situation, simulation starts even if they are not spawned and, when this happens, they have already moved (similarly to ALive VI system) but (although I'm not sure) without interacting with other units, spawned or not. Any suggestions or corrections? Thanks!
Hi! I tried using Dynamic Simulation to increase framerate in my mission, but surprisingly it doesn't work. The units which have DS enabled don't "wake up" at all. The simulation does not start, therefore I have quite a big problem. If I disable DS for a unit, the simulation goes normally, same for global disabling of DS - all units behave as they should. I'm using 3den Enhanced, but don't think that's what's causing this situation, since I've read that it works normally with 3E. Any ideas where the issue lies?