Jump to content
Sign in to follow this  
Billy Bones

Beta 61362 Sniper

Recommended Posts

Using the editor I was trying out the sniper with the bipod , man at end of runway I zoom in + middle of chest .. shot kicks up dirt on ground about 3-4ft to his left another shot again + middle of chest shot kicks up dirt 3-4ft to his right.

I had the skill slider full .. no expert on ballistics but I was only some 600 yards from him and I was prone on the runway with rifle with bipod.

Share this post


Link to post
Share on other sites

do you know the name of the rifle? it could make a big difference depending on which one it was...

Share this post


Link to post
Share on other sites

Which rifle were you using? Were any additional mods active that could affect weapon accuracy? Which distribution of the game do you have? (Steam, Nexway, Retail etc.)

Share this post


Link to post
Share on other sites

Sniper with M107 .. PCDVD

---------- Post added at 10:12 PM ---------- Previous post was at 09:55 PM ----------

th_sniperm107m.jpg

Edited by Billy Bones

Share this post


Link to post
Share on other sites

I just tried it out like you described:

Sniper(M107) on Utes and an enemy rifleman at 550 m. I hit every time. You should too, since the scope is zeroed at that distance.

Share this post


Link to post
Share on other sites

Does your scope jump up and away with the kick of the shot ? I just thought that was a bit much as I was prone and the ground and using the support of the bi-pod, the kick is really big.

Share this post


Link to post
Share on other sites

I have no probs with 107 in 062 but you are standing in that vid not prone???

Share this post


Link to post
Share on other sites

No ... Basic game 1.04 with beta patch..

I went back to 1.04 official release and used the same sniper with the m107. Standing I hit the target, prone I hit the tartget again I fired off the rounds and they hit the dirt in the same line some up some down but all in the same vertical line, non of shot hit right or left as they do with the beta, so its the beta patch.

---------- Post added at 11:05 PM ---------- Previous post was at 11:04 PM ----------

I have no probs with 107 in 062 but you are standing in that vid not prone???

Prone .. as my post above I went back to 1.04 official release patch and the m107 worked fine I hit the target standing and prone, so its the beta patch where the problem is coming from ..

---------- Post added at 11:13 PM ---------- Previous post was at 11:05 PM ----------

So far in editor with the latest beta the sniper is off an all standard rifle and m107 , when commanding a M1A2 tank and tell gunner to target the T90, the greeen target box with inner circle appears round the T90 but its only the machine gun that fires.

In scenarios , when I jump into an AI APC (passenger) it never opens fire on the enemy even when fired on. I can hear the direction commands and the driver reacts to them , but when I hear the Cannon order it does not fire.

Share this post


Link to post
Share on other sites

Strange... I tried both: beta 61362 alone and ace. 9/10 hits.

Make a statistic. Try the same layout at least 10-times (the one you have on picture above) go prone, hold breath and shoot (with the beta of course)... Then report in hit%. Because now we really can't know whether you just shot 2 times and had bad luck or you tested it out more.

By the way: The skill slider is meant for AI only - it won't affect your grouping of shots (I think).

Edited by sprayer_faust

Share this post


Link to post
Share on other sites

Hi all

Billy Bones which publisher did you buy ArmA from?

I ask because this is one the things said to happen if the copy protection system sometimes called FADE kicks in.

Kind Regards walker

Edited by walker

Share this post


Link to post
Share on other sites

got it from local gamestation on the box is BI and 505games

Fade as far as I can remember kills the game , the game is working fine I installed Official patches 1.02 1.03 1.04 and the sniper rifle m107 works fine I get hits on target Standing and Prone. But with the latest beta the scope of some reason is out .. when I got back to the official release ver 1.04 it works with no problem.

If it was FADE , then it would do the same with 1.04 too ...

Share this post


Link to post
Share on other sites
Sniper with M107 .. PCDVD

your firing an m107 while kneeling? of course its gonna be inaccurate

Edited by Rellikki
Quoted hotlinked image

Share this post


Link to post
Share on other sites

our firing an m107 while kneeling? of course its gonna be inaccurate

that's the start of the video , when I got to scope I then go prone. as I said when I got back to the official release patch 1.04 I can hit the target with the M107 Standing Kneeling and Prone .. the problem is with the beta ..

Share this post


Link to post
Share on other sites
the problem is with the beta ..

Can you open your Private messages, and respond to me, please?

Share this post


Link to post
Share on other sites

Sure u aint got a NO-CD crack from some place? That usually triggers fade

Share this post


Link to post
Share on other sites

As for the armor issue I have had the same problem using 1.04. It seems you have to give them a target and then also order them to fire.

Share this post


Link to post
Share on other sites

ehm darkhorse ? here you are in a sniper rifle precision problem :)

the post you seek is the T90 armor problem :)

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×