maxjoiner 284 Posted November 6, 2016 Hi all, I'm developing a new Skyscarper (I already done two), to improve it I added also the RVMAT files (three Rvmats Front, side and top). But If I use them my new Skyscarper disappears when I go far from it, and then It reappears when I go close... Together the Skyscarper there are other my two buildings, where I used the same Rvmats... But they don't disappear..... The Three Buildings (House, shop and Skyscarper) have the same config, model.cfg and Rvmat (I changed only some tex like NOHQ and SMDI, but only the skyscarper has this bug... I tried to resize it, but also smaller it had the same bug.... I tried to add more resolutions LOD but nothing....... Watch the screens: Any Ideas?! Share this post Link to post Share on other sites
m1lkm8n 411 Posted November 6, 2016 I would say it is too big. You will need to split the structure up into 60 meter x 60 meter chunks. Anything over 60 meters from the origin structures tend to get wonky Use proxies to fix the issue Share this post Link to post Share on other sites
maxjoiner 284 Posted November 7, 2016 I already tried to make it of 45x45 but nothing.... the same bug.. If I don't use the RVMAT It works fine..... Thanks.... Share this post Link to post Share on other sites
opteryx 1562 Posted November 7, 2016 (edited) edit: nevermind Edited November 7, 2016 by opteryx Share this post Link to post Share on other sites
m1lkm8n 411 Posted November 7, 2016 If you don't want to share it here you can always pm on skype or discord if you want an extra set of eyes on it Share this post Link to post Share on other sites
Auss 208 Posted November 7, 2016 sometimes when the geolod is too big and "pokes through" the res lod, it will cause this problem Share this post Link to post Share on other sites
x3kj 1247 Posted November 7, 2016 canocclude and canbeoccluded properties? Share this post Link to post Share on other sites
maxjoiner 284 Posted November 8, 2016 If you don't want to share it here you can always pm on skype or discord if you want an extra set of eyes on it Thanks for Your offer, I'm making some test if I'm not able to fix I'll write You... sometimes when the geolod is too big and "pokes through" the res lod, it will cause this problem I tried to add more res Lods, 4 exactly.... but I had another problem, the Skyscraper is visible but It uses the last res lod, So It start in low res.....why? to understand better lod 1: Lod res = points 7000 faces 8000, Lod 2: Lod res = points 2000 faces 3000,...... Last Lod res = points 100 Faces 200..... The skyscarper is visibile with the last lod res.... canocclude and canbeoccluded properties? I tried with both the commands, with 0 and 1 value....nothing... Share this post Link to post Share on other sites
maxjoiner 284 Posted November 8, 2016 Well, People I understood the problem and I fixed that Bug.... :D The multiple Rvmats were the problem, If I use one Rvmat the Skyscarper works fine also from far.... Here is because Bohemia uses Rvmat multimaterials..... ;) Thanks to all! :rolleyes: Share this post Link to post Share on other sites
