Model's texture in buldozer with visitor 3

Hi all,

this is what i see in buldozer when i use my visitor 3:

Do you have information to have textures?

(i unpbo all the buildings in p:\CA\buildings)

a2 addons?

Do you make sure to load with the buldozer.exe?

yep i use only arma2 addons, you see et watertank with good texture but many p3d are black perhaps bugs from original p3d??

Make sure you dont use the "ruins" or you'll get that problem

All the "buildings2_Ind_CementWorks" are black

ingame also?

ingame also?

In game it's good, but its very difficult to use it in visitor for good using with other parts....

Did you try to tweak the arma2.cfg or arma2profile for the buldozer exe - at least I assume it also has one.

need to take ur arma2.cfg and point bulldozer to it

When you install the A2 tools, O2PE will (should) already have the appropriate commandline parameters set under O2 File>Options.

That is it should already have...

"p:\buldozer.exe" -window -buldozer -noland

When you launch buldozer from O2/V3 for the very first time if there is a P:\buldozer.cfg then buldozer loads it and utilizes the parameters within.

If the .cfg doesn't exist then buldozer.exe will create a new buldozer.cfg with the basic default settings.

Whether it exists or not after the first launch of buldozer one should then immediately close the viewer.

Next you should then open the buldozer.cfg file in a text editor.

Change the following 2 parameters as follows and then save the .cfg and close your text editor.

FSAA=0;
postFX=0;

From this point you shouldn't have any more problems with 'black' textures as per your first post.

Give it a try, hopefully it'll solve your issue.

works fine for me with fsaa on 4

ok, cool, and postFX?