wipman 1 Posted August 2, 2007 Hi, this is what i get when i try to scale down a part of a (stolen) model: '0.97' is not a valid floating point value. A message that i don't know why appears; apart of the reaon that it displays... as undo, i use the history table at the bottom right corner; but yes, it haven't a CTRL+Z (= Undo) option. Let's C ya Share this post Link to post Share on other sites
wipman 1 Posted August 2, 2007 Hi, as Jello Biafra (God on Earth) said once: "im an asshole." ; thanks MehMan now works. In the O2 was 0.93 not 0,93 for scale down, this evidences EVEN, more... that the 3D's is not my field. Let's C ya Share this post Link to post Share on other sites
-10thMT-Tack-Up 0 Posted August 2, 2007 Does it run with vista cause i get this error when i open it up? Share this post Link to post Share on other sites
[aps]gnat 28 Posted August 3, 2007 Arh .... the "Don't write this error message down because everyone will know what it is" error ..... Always a problem that one. Share this post Link to post Share on other sites
MehMan 0 Posted August 3, 2007 Install Dx9.0c in Vista to make it run. Dx10 and Dx9 can run side by side. Share this post Link to post Share on other sites
stuck101 1 Posted August 16, 2007 is there instructions on how to use it, if there is where are they? Share this post Link to post Share on other sites
Blackbuck 9 Posted August 16, 2007 Same controls as O2 on the whole allthough some don't work. Mess around a bit with a model and you'll get the hang of it Share this post Link to post Share on other sites
