Is there a key sequence to escape out

[unclepogy 0]

Hello -- when I start O2 light, it checks for the CD OFP CWC, and then it runs the external viewer. Question: Is there a key sequence that I can use other than CNT ALT DEL to escape out of the viewer so that I can use O2? Thanks in advance. Uncle

[Guest]

ALT+F4

Edit: I should perhaps add that in your O2 preferences you should add "-window" to your external viewer parameters. Bulldozer opens up in a window then (instead of fullscreen) and you can work with both Bulldozer and O2 open.

[IliektingsdatgoBOOOM 0]

Just a quick followup question:

If you edit with both oxygen and buldozer open, does whatever you edit in oxygen automatically gets updated in the bulldozerwindow or do you have to press the black/yellow button in oxygen to redraw it in buldozer?

Thanks

[scousejedi 0]

WHen you load O2 it loads the viewer so you have little choice in the matter...

You have to update it with the little yellow button.

[SelectThis 0]

I don't think you need to press that little button to update, it updates as it goes. At least that is my experience with it.

I normally modelin O2 with the REs CD in, meaning buldozer doesnt load up. I only use buldozer when texturing.

PS: use alt tab to switch from buldozer to O2.

SelectThis

[colonel_klink 0]

Sometimes it takes a while for Buldozer to update any changes. When this happens I view a different lod and then switch back to the lod I was working with. This sometimes refreshes Buldozer. The only method I've found that works is my unloading Buldozer then reloading it.

[zwadar 0]

</span><table border="0" align="center" width="95%" cellpadding="3" cellspacing="1"><tr><td>Quote (SelectThis @ Sep. 15 2002,12:27)</td></tr><tr><td id="QUOTE">PS: use alt tab to switch from buldozer to O2.<span id='postcolor'>

I think pressing "`" will be better. Its key beside "1" over TAB .. :-)

[FlipeR 0]

You dont need to do anything, Buldozer will be automaticaly updated! No LOD switching is needed although in the case of heavy models it can take a while, since the engine must load all those textures, effects, polygons, etc,...

Zwadar, the "´" thing works only one way -> from O2L to Buldozer.

And to close Buldozer, beside Alt+F4 U can also use that "little yellow" button which in fact togles Buldozer on/off.

FlipeR

[zwadar 0]

</span><table border="0" align="center" width="95%" cellpadding="3" cellspacing="1"><tr><td>Quote (FlipeR @ Sep. 15 2002,13:46)</td></tr><tr><td id="QUOTE">Zwadar, the "´" thing works only one way -> from O2L to Buldozer.<span id='postcolor'>

You havent got buldozer in window?

Because I have buldozerin window and it works in booth ways. amazing..

[Guest]

</span><table border="0" align="center" width="95%" cellpadding="3" cellspacing="1"><tr><td>Quote (FlipeR @ Sep. 15 2002,14:46)</td></tr><tr><td id="QUOTE">Zwadar, the "´" thing works only one way -> from O2L to Buldozer.<span id='postcolor'>

"`"works both ways but out from Buldozer back to Oxygen it works only if u was switched into it by this key...

But i'm using often Alt+Tab. If it fails, try for escape from Buldozer Ctrl+Esc.