terox 316 Posted April 22, 2016 Instructions on how to: In your BattleEye\BEServer.cfg file add the following NB>> try initially by not assigning an IP, this can cause problems RConport **** RConIP **.**.**.** Example RConport 2301 RConIP 77.72.53.21 The RConPort should not be any of the game ports the ArmA3 server uses So either use GamePort + 4 or Gameport -1 if you want to keep them all together in your firewall rules Remember to open these UDP ports in your firewalls. You then need to edit your RCON tool and reset the port from the game port to the newly defined RConport The RconIP typically shouldn't be required, unless your BE is hosted seperately. However if you are having issues try then defining it, initially try without it I personally use a -profile switch to define my server install location and do not need to define the IP Hope that helps a few of you. 1 Share this post Link to post Share on other sites
terox 316 Posted April 22, 2016 I edited the previous post. I run multiple servers from the same IP on a Linux box and found that if I defined the IP, I was unable to connect via RCON to any of the servers Share this post Link to post Share on other sites
Dwarden 1124 Posted April 22, 2016 RconPort must avoid reserved ARMA3server port range default reserved ports (+0,+1,+2,+3) are 2302 - 2305 to clarify the reserved ports can't be used for BattlEye's RCON you also shall not need to add the RconIP entry as undefined equals to 0.0.0.0 (all IPv4 local IP addresses) setting it to e.g. 127.0.0.1 will prevent it to respond on external IP setting it to e.g. external IP will prevent it to respond on localhost 127.0.0.1 Share this post Link to post Share on other sites
terox 316 Posted April 24, 2016 Updated instructions are now correct 1 Share this post Link to post Share on other sites
mygedz 0 Posted April 27, 2016 Very helpful! Thank you Share this post Link to post Share on other sites
manzarek 14 Posted April 27, 2016 How to make maxping work? Share this post Link to post Share on other sites
Dwarden 1124 Posted April 27, 2016 maxPing is disabled, the message clearly says it, until further notice Share this post Link to post Share on other sites
mygedz 0 Posted April 28, 2016 maxPing is disabled, the message clearly says it, until further notice That's understandable. But how to enable? Share this post Link to post Share on other sites