Basic command: Walk...where is it?

[bullman 0]

Hi

I think I have tried getting an answer to this question a while ago with no luck.

Is it possible to give orders to infantry you control so that they WALK to a location without following you (like they would on patrol/scout)?

If not, why not? It seems silly that there is no order for this.

Are there any mods that allow you to order infantry to walk to a location?

Cheers

Bull

[froggyluv 2130]

Are you specifially meaning "Walk" or just move? You can highlight your men and click on either terrain or map and tell them to go -anywhere.

If you intended walk only -set them to Careless behaviour and maybe that'll work.

[bullman 0]

Are you specifially meaning "Walk" or just move

Come to think of it, what I really am after is actually something like PATROL, the same kind of order enemy AI in missions can be scripted with.

ie. infantry travel at walking speed, scanning around them for enemy as they move.

If you intended walk only -set them to Careless behaviour and maybe that'll work.

A soldier on PATROL would not want to be careless.

MODE / STANCE/SPEED / ABILITY TO DETECT ENEMY / ABILITY TO BE DETECTED BY ENEMY

Stationary / Prone / ZERO / LOW / LOWEST

Stationary / Standing / ZERO / HIGHEST / LOW

Crawl / Prone / SLOWEST / LOWER / LOW

Walk / Standing / SLOW / HIGH / MED <---on PATROL. Where is this order?

Run / Standing / FAST / LOW / HIGHEST

[Joe98 90]

I too have found this.

When you order members of your team to move over there, they always run.

There does not seem to be a "patrol to that spot" order.

.

.

[bullman 0]

I too have found this.

When you order members of your team to move over there, they always run.

There does not seem to be a "patrol to that spot" order.

.

.

Good to know that I am not the only one who sees the value of such a walk/patrol command. I mean, its a STANDARD kind of military order in real life anyway. Why isn't it in ArmA? In ArmA it's either crawl or run. Kinda ridiculous really.

[Gunter Severloh 3955]

As froggyluv said click on the terrain you want them to go to and they

will go there but give them the safe order ~ then 7, 4 and they will walk to their destination.

[Joe98 90]

But if you give them the "safe" order that uis very dangerous as there could be enemy around.

.

.

[Gunter Severloh 3955]

Obviously your in command, your the one that should be paying attention.

However you can give orders for the AI to watch specific directions, the AI do see, and hear, and can report,

when they do it is up to you to decide what action is best.

[bullman 0]

As froggyluv said click on the terrain you want them to go to and they

will go there but give them the safe order ~ then 7, 4 and they will walk to their destination.

Hmm...I will try that. :o

[Trapper 0]

Also "safe" isn't "careless" which is editor only.

It will change to "combat" automatically whenever the ai expects enemy contact by itself. Though of course the ai isn't as prepared but it was walking what you were asking for.

[bullman 0]

As froggyluv said click on the terrain you want them to go to and they

will go there but give them the safe order ~ then 7, 4 and they will walk to their destination.

Well I was off playing ArmA2 for a bit and never tried what was suggested here. I finally have cranked up ArmA2 again and have given it a go.

Well, the units STILL don't walk. They kind of start walking, then break in to a run, then for a fraction of a second look like they are going to walk but then start running again. :confused:

So, back to the original post: How do I order my units to WALK to a position?