Jacky60 10 Posted May 4, 2010 Using cat 10.4 and my trifire setup artifacts -triangles flashing textures if I go above 850 core (1.162 volts). The 5970 is overclocked the 5870 at stock but it won't do 900 mhz without lots artifacts in a fgew seconds. GPU temps (especially GPU 2 on 5970) above 60c seem to be the cause yet 5970 supposed to be good til 75-80c. Have BIS not implemented trifire fully in drivers yet? PS fans at 100% Share this post Link to post Share on other sites
kklownboy 43 Posted May 5, 2010 Using cat 10.4 and my trifire setup artifacts -triangles flashing textures if I go above 850 core (1.162 volts). The 5970 is overclocked the 5870 at stock but it won't do 900 mhz without lots artifacts in a fgew seconds. GPU temps (especially GPU 2 on 5970) above 60c seem to be the cause yet 5970 supposed to be good til 75-80c. Have BIS not implemented trifire fully in drivers yet? PS fans at 100% its not always about temp, its usually about volts( to much juice can artifact no matter the temps, and its a Memory volts temps that fail, not so much the GPUs), And setting your ingame Memory to Veryhigh should fix alot of the issues except you can get other issues, i use Default in my quad set up. Share this post Link to post Share on other sites
Fox '09 14 Posted May 5, 2010 it's not really ArmA 2's fault.. although there isn't really any other section for this... or is there. Share this post Link to post Share on other sites
Dwarden 1125 Posted May 5, 2010 please inform AMD.ATI driver team about this issue ... Share this post Link to post Share on other sites