Position for Backpacks (ACE)

[clawhammer 10]

I have a small ask,

how can i adjust the position on an Infantry Model so that Backpacks (these from ACE) are in the right position?

On my model the backpack is a little bit displaced :butbut:

Thanks for help!

[Binkowski 26]

What do you mean, placement on the model? Or where the ruck sacks are attached with ACE? I believe the rucks are attached to the selection "SPINE" in ACE. I could be wrong however. The image below shows the position of an ILBE ruck.

Reference

[clawhammer 10]

I mean the ACE Backpacks, these wich you can grap from the weapon chest.

When i pick up such an Backpack its not correct fitted to my model.

What i had to fix this up?

thx!

Edited January 31, 2010 by Clawhammer

[clawhammer 10]

Here are some pics of what i mean:

Its an backpack from the ACE Backpackchest. Its too much on the left side O.o

What can i do?

[Jackal326 1182]

As far as I was aware that was an issue with the ACE Backpack models themselves not being correctly placed, as I seem to remember them doing that on stock units too. That said, I may be wrong.

If you go an adjust the AT launcher proxy to compensate, it'll bugger up using AT weapons (as they wont sit correctly in your hands), so I believe its down to ACE to fix that.

[clawhammer 10]

But it looks on all units fine just on mines :/

UPDATE: Ok i tested it with differnt units, its not just on mines.

Ok if thats an ACE related thing i will create an ticket for it.

UPDATE2: Ticket created here: http://dev-heaven.net/issues/8844

thx Jackal326 for your info :)

Edited February 5, 2010 by Clawhammer

[nzdfcrash 33]

i get the same thing with my aussie regular force and nz regular force units ive done up so your not the only one

[Panda_pl 0]

The center of selection is the point for adding the attachment. You can offset it by adding a single verticle a bit to the side of soldier and adding it to the SPINE selection, that will offset the center of selection.