floosy 0 Posted August 1, 2008 Hi all, i just need help (lol just). I ve made an island, but i need to change my mask and sat on this map. When i try to import mask and sat, there is an error message: "Error Loading 'p:' " i have re-install all the tools of arma and the p:, i tryied a new map to test but i always have this error, do you have some solution? thx , and i m sorry for my bad english http://www.team-saaf.fr/ Share this post Link to post Share on other sites
dmarkwick 261 Posted August 3, 2008 Look for your ArmAWork folder, and within that the mapdisk.bat file. This is the .bat file that should be executed every time you boot up, to give you your P: location. If you do not see a P: location in your Windows explorer, you need to execute this .bat file. Share this post Link to post Share on other sites
floosy 0 Posted August 3, 2008 Yes but i have my p: in my desktop, only visitor can't see it. Share this post Link to post Share on other sites
dmarkwick 261 Posted August 3, 2008 Then take a quick look at the menu item Tools/System Preferences & check those paths are OK. Other than that, I don't know much else. Share this post Link to post Share on other sites
floosy 0 Posted August 3, 2008 all is good in visitor. I tried 5 textures on map do you think it possible to make problem in the .pew? When i try the last 4 texture there is the same error. Share this post Link to post Share on other sites
OChristie 0 Posted August 4, 2008 You will want to make sure that your ArmAWork Folder is in your My Documents Folder, then, If that is not it, You will want to make sure that all the terrain Sat and Mask settings are the same as before also the new texture layer you imported is say the default of your project: i.e Base(Layer) = 40.0 x 40.0 - New Layer = 40.0 x 40.0 Hope it helps! blackknight63 Share this post Link to post Share on other sites
floosy 0 Posted August 4, 2008 i modified my sat and just want to re-import this, but not possible. visitor can't load p:... very strange Share this post Link to post Share on other sites
OChristie 0 Posted August 4, 2008 try: 1. Uninstall the whole tool suite EVERYTHING!!!! 2. Re-Install and make sure ArmA Tools are installed properley, install everything 3. Check that a folder called ArmAWork exists in your my documents area, if not create one and then copy everything form your previous ArmAWirk folder. 4 Run Mapdisk.bat and then restart your PC Share this post Link to post Share on other sites
floosy 0 Posted August 4, 2008 I ve done what you say but no change. I tried to begin a new project to test the software, and the same error appeared. Share this post Link to post Share on other sites
floosy 0 Posted August 11, 2008 Ok all is ok now, thx all for your help. Admin you could destroy this post, it was alayers.cfg mistake. Share this post Link to post Share on other sites
