Tires are not tuching ground on ported arma2 vehicle

[sceneryexplosion 10]

As the title says I am working on porting an arma 2 vehicle but i cant get the wheels to tuch the ground.

Image showing the problem: http://i.imgur.com/DVa9LfW.png

[maxjoiner 284]

Did You do land Contact lod?

Watch the example car.... there are also this memory points to add:

posun wheel_X_X (on all the wheels)

two points for wheels, one on the wheel's center, other upper the first on the tyre...

[sceneryexplosion 10]

Yea I have it all set up but it is still not working :/

[maxjoiner 284]

Post some object builder immages of your vehicle......

I need to see if It has all the lods right...

[sceneryexplosion 10]

Here are all my lods:

http://i.imgur.com/IAl1OAo.png

http://i.imgur.com/nkcU2RR.png

http://i.imgur.com/SHQTA8d.png

LandContact LOD: http://i.imgur.com/0LVLeQv.png

[maxjoiner 284]

Why (in land contact lod) the wheels have the memory points not under the wheel's center?

however I need to see all (a complete immage) your vehicle lods....

Otherwise I should to have a Crystal Ball........:).

[Armod 10]

Check your model.cfg and check the damper animation settings.

Here is a screenshot of that very vehicle:

http://gyazo.com/5598e507cacdc05f4be7038b662f6b21

That is a version that was given to me, The screenshot was made by the author of the addon.

[Varanon 892]

Did you set up the mass correctly in Geometry LOD ? Also, make sure sprung mass and derived values in class wheels are correct.

[sceneryexplosion 10]

I raised the tire weight in the config, so the wheels are now tuching the ground. Thanks everyone for the help. Yet again you have proven that the BIS community is the best :)