Cionara 10 Posted October 3, 2009 I set up my Track IR 5 for ArmA2 and it's working fine. And because I am the smartest guy of the earth I added additionally moves like evading right/left when rolling the head. I also wanted to add duck/ standing up when using the Y axis, I can assaign tY+ and tY- but ingame nothing happens why I move up or down. Someone an answer for this ? Share this post Link to post Share on other sites
Akilez 10 Posted October 3, 2009 (edited) I'm not certain but I don't think ArmA 2 supports that movement (vertical) for TIR. It's a 6DOF arrangement which equates to: -Rotate left/right=2 -Lean left/right=2 -Zoom forward/aft=2 -------------------------- Total = 6 DOF (Degrees Of Freedom) Again I am not 100% certain but this is my understanding. . . . Edited October 3, 2009 by Akilez typo Share this post Link to post Share on other sites
Cionara 10 Posted October 4, 2009 It assigns it to the moves so it recognizes it. Same with roll, and roll is working. -Rotate left/right=2 -Lean left/right=2 -Zoom forward/aft=2 -Roll left/right=2 That are already 8, right ? Y axis I am figuring out, why shouldn't it work, too ? But yea I wondered why they didn't use the roll default. Maybe was just a very smart idea of me who knows... Share this post Link to post Share on other sites
Maverick806 0 Posted October 5, 2009 (edited) I'm not certain but I don't think ArmA 2 supports that movement (vertical) for TIR.It's a 6DOF arrangement which equates to: -Rotate left/right=2 -Lean left/right=2 -Zoom forward/aft=2 -------------------------- Total = 6 DOF (Degrees Of Freedom) Again I am not 100% certain but this is my understanding. . . . Those are only 3DOF (ArmA supports 4/6) The 6Degrees of freedom are: Yaw - rotating about the x axis (looking side to side) Pitch - rotating about the y axis (looking up and down) Roll - rotating about the z axis (not used by default in ArmA) X - moving along the x axis (lean) Y - moving along the y axis (not used by default in ArmA) Z - moving along the z axis (zoom) As for why binding the y axis to stand up or go prone doesn't work, my guess is that it's because the expected input is a keystroke not a scaled amount. Edited October 5, 2009 by Maverick806 possible explaination Share this post Link to post Share on other sites
maddogx 13 Posted October 5, 2009 Cionara, perhaps you need to increase Y-axis sensitivity in the TrackIR software. :) Share this post Link to post Share on other sites
