nightwisher 10 Posted July 23, 2009 When I try to synchronize a trigger with a waypoint, the people just ignore the triggers and run straight to the end of the path. I've tried grouping the trigger with me, setting a conditional to "true", but I can't get them to obey? Is there a different way of doing it or is it not in? Share this post Link to post Share on other sites
Master gamawa 0 Posted July 23, 2009 You need two way points. One to set the start position and a second to set the destination. sync the trigger to the first waypoint. The second waypoint is where you want the unit to move after the activation of the trigger. Share this post Link to post Share on other sites
-)rStrangelove 0 Posted July 23, 2009 Also, the 1st waypoint is always at the pos where you put the unit in the editor. This waypoint cannot be used though, except via scripting. Share this post Link to post Share on other sites
Master gamawa 0 Posted July 23, 2009 I usually put the first way point a couple of yards away from the unit. They take two steps and they stop until the trigger is activated. Share this post Link to post Share on other sites
