Blackdog 0 Posted February 25, 2007 When using the editor I have noticed a problem where I may put a group on a bridge, for example, not placing correctly. On initial placement (of a group) the editor will place some on the bridge and some in the water alongside. Even after I manually place the units on the bridge I notice the units are still in the water. I have also noticed units being placed on the roofs of buildings even after I have manually place them Is this a known problem and is there a workaround? Thanks in advance. Share this post Link to post Share on other sites
Jack-UK 0 Posted February 25, 2007 i'm a noob editor.. But i *think* if you set the Special on the edit solder screen to None (or anything except In Formation) they will appear where you want them to Give it a try Share this post Link to post Share on other sites
Blackdog 0 Posted February 25, 2007 thanks for quick response. will try that now I do tend to leave units etc in formation setting Share this post Link to post Share on other sites
mattxr 9 Posted February 25, 2007 i'm a noob editor..But i *think* if you set the Special on the edit solder screen to None (or anything except In Formation) they will appear where you want them to Give it a try Yeah what he said should sort your problem, but then your have the problem of the AI will start to run to your leaders position. So its best to have them single or Disable the AI movement. Share this post Link to post Share on other sites
