Looking for addon camapigns that work

[jfri 0]

I'm trying to play addon campaigns but I often find out that they don't work. For example at ofp.gamepark.cz I tried the first listed campaign Bas_Alta_Tension. I installed the listed required addons. But still I got error messages telling me about missing m60 addon. I searched for m60 and found four items. tried one but still no success (it's not even possible to exit the campaign but I have to close down the whole OFP).

So I would like to know which campaigns do work right away? I don't have time troubleshooting and searching and trying out addon files not explicitely listed as required for the campaign. I use the GOTY edition and has the 1.96 patch installed.

[Thomas Ryan 0]

Hi jfri!

Are you sure it was 'm60' or the BAS Blackhawks addon 'mh-60' because I seem to remeber it being required for that campaign.

Also, try reading the readme, it may state other needed addons for the campaign to work (ofp.info doesn't always show ALL of the required addons for the campaign/mission.)

Anyways, good luck sorting it out!

P.S: If you don't have all the necessary addons required for that campaign and the intro doesn't need them but the mission afterwards needs them then you'll get an error message saying 'Cannot load mission; missing addon 'xxx'', then the cutscene will repeat over and over again and you'll have to close down OFP to stop it.

[action man 0]

Ok (put's on placebo head ) First you have posted in wrong section,should have been user missions.second you should have done a search! Here you go click this fourth post down. Wow that made me feel good

[jfri 0]

Hi jfri!

Are you sure it was 'm60' or the BAS Blackhawks addon 'mh-Also, try reading the readme, it may state other needed addons for the campaign to work (ofp.info doesn't always show ALL of the required addons for the campaign/mission.)

Anyways, good luck sorting it out!

P.S: If you don't have all the necessary addons required for that campaign and the intro doesn't need them but the mission afterwards needs them then you'll get an error message saying 'Cannot load mission; missing addon 'xxx'', then the cutscene will repeat over and over again and you'll have to close down OFP to stop it.

Yes I took a note and it's m60. I have read the readme file and it does not mention any m60.

[jfri 0]

Ok (put's on placebo head ) First you have posted in wrong section,should have been user missions.second you should have done a search! Here you go click this fourth post down. Wow that made me feel good

I did use the search, and by all means my specific problem was addressed here.

But not the question, which camapaign works right away without the need for searching and resolving errors even after following the installation instructions?