echo1 0 Posted September 28, 2005 Ok, I know very little about using O2, i was messing around with a model and I wanted to make it smaller, I read you needed to use some scaling tool, but I dont know where this is or how to use it, can anyone give me some help? Share this post Link to post Share on other sites
colonel_klink 0 Posted September 28, 2005 1. Select the model or part to scale. 2. Ensure the UNIFORM SCALE toolbar button is selected (depressed). 3. Hold down CTRL + SHIFT and the RIGHT MOUSE BUTTON and move the mouse. The scale shown in percentage (Scale = 100 etc) should appear on the lower left of the O2 workscreen. If it doesnt ensure that the STATUS BAR is selected from the Windows menu in O2. Share this post Link to post Share on other sites
echo1 0 Posted September 28, 2005 Ok, i tried all that but it just seems to rotate the model, the uniform scale is depressed. Share this post Link to post Share on other sites
JdB 151 Posted September 29, 2005 What our Addonmaking Master was trying to say is: 3. Hold down CTRL+SHIFT and the RIGHT MOUSE BUTTON and move the mouse. Share this post Link to post Share on other sites
colonel_klink 0 Posted September 29, 2005 LOL thanks Lt HuNTeR. Its funny. I had actually gone back into O2 to check then typed in the wrong key combination. That is the trouble when one has a break from modeling. Sorry, ch_123. See how teamwork gets things done Share this post Link to post Share on other sites
