SNAFU 0 Posted July 25, 2016 Hello, While attempting to use pboProject to create package my map, I have run into a few problems I would like some assistance with. When attempting to pack I recieve this error within the output(s) file: s_satout_co.paaenvironment.hpp : ignored or mergedsosopol.hpp : ignored or mergedsosopol.wrp scanning wrp checking for missing files...In File \cup_terrains_ca_misc\config.bin: invalid fileERROR: \cup_terrains_ca_misc\config.bin is faultyThe addon name for \cup_terrains_ca_misc\bilboard_pizza_presto.p3d cannot be determined ------------------------------------------------------------------------ And in the CMD Console I recieve this: <Bis Binarise...> </Bis binarise> stripping the binlogMakePbo x64UnicodeVersion 1.92, Dll 5.52 "sosopol"pbo: reqaddons. could not find a cfgpatches class for wrp file refsmakepbo failed ------------------------------------------------------------------------ As far as I am aware I have set up the addons currectly when extracting them from their respective .PBO files, Below is an image link showing the P Drive: https://gyazo.com/49e7217bf5869c177fb08c31b6d1d488 I have re-downloaded the file, twice, and attempted to fix the problem by replacing them with freshly extracted files, but to no avail. Any help is much appreciated. Best Regards, Harry K Share this post Link to post Share on other sites
RoF 240 Posted July 25, 2016 You have extracted them wrong, they should be a "ca" and "cup" folders. If your just double clicking the pbo to extract them using extractpbo, it puts them as "filename\ca\etc". You want to move the ca folder to P:\. Sometimes they are called cup instead of ca, but its the same way, move it to P:\. Share this post Link to post Share on other sites
SNAFU 0 Posted July 25, 2016 You have extracted them wrong, they should be a "ca" and "cup" folders. If your just double clicking the pbo to extract them using extractpbo, it puts them as "filename\ca\etc". You want to move the ca folder to P:\. Sometimes they are called cup instead of ca, but its the same way, move it to P:\. How would I go about extracting them properly? And thank you for the reply. Share this post Link to post Share on other sites
R0adki11 3949 Posted July 25, 2016 How would I go about extracting them properly? And thank you for the reply. Perhaps ask in the CUP Terrains Thread: https://forums.bistudio.com/topic/186835-community-upgrade-project-cup-terrains/ Share this post Link to post Share on other sites
RoF 240 Posted July 26, 2016 How would I go about extracting them properly? And thank you for the reply. I did mine one by one! Sorted the folder by file type, then just used the arrows to move down the list, pressing enter on everyone. Then I searched for ca in the cup core folder and moved all them folders to P:\. Then did the same for the "cup" folders. If you install extractpbo, it should set the file association automatically for you. I did try extracting the whole folder in the command line, but it bugged out. Share this post Link to post Share on other sites
SNAFU 0 Posted July 26, 2016 I did mine one by one! Sorted the folder by file type, then just used the arrows to move down the list, pressing enter on everyone. Then I searched for ca in the cup core folder and moved all them folders to P:\. Then did the same for the "cup" folders. If you install extractpbo, it should set the file association automatically for you. I did try extracting the whole folder in the command line, but it bugged out. Thank you, I managed to get it working, once you said extractpbo, i tried it, and it worked! Share this post Link to post Share on other sites