soapboxsubmarine 11 Posted June 12, 2015 Like in the title, When i place a runway part, they are invisible if i close buldozer and open it again, it appears, but then you cannot move it or select it Anyone has a solution lying arround? Share this post Link to post Share on other sites
KokaKolaA3 394 Posted June 13, 2015 I have the same problem, but you can move the runway in Terrain Builder you dont need Buldozer. But you can turn and move the runway in Buldozer, select the object in Terrain Builder and the rotate it with Buldozer, its a little bit diffycult but it works. Share this post Link to post Share on other sites
soapboxsubmarine 11 Posted June 24, 2015 aha , ok good. a bit teedy but if nothing else its a way to do it at least. Thnkks Share this post Link to post Share on other sites
Guest Posted June 26, 2015 Hey, well the problem is the editor.sqs, which you are using to see the normal roads, I guess. If you dont, ignore this ;). Too edit your runway properly you have to rename the editor.sqs in the P:\scripts folder ; I always only rename it to editor_off.sqs, then you restart Buldozer (I hope for you, that you have a ssd :D) and then you can edit it. Afterwards you change it to the normal name and restart Buldozer again. ir0n Share this post Link to post Share on other sites
soapboxsubmarine 11 Posted July 9, 2015 ok, this i will try, thanks for tip Share this post Link to post Share on other sites
