JesseDavis 1 Posted December 19, 2011 would be nice to have a widget or display somewhere that shows what trim, if any, is set. when using buttons to tune the trim i find it hard to figure out how much change has occurred whilst wrestling the stick at the same time. rudder trim seems easy but cyclic trim much harder. numbers/deltas/bar charts? (okay 3 threads in 5 minutes - I'll shut up now) J. Share this post Link to post Share on other sites
Slapstick 10 Posted December 20, 2011 plus 1 (just +1 is too short) Share this post Link to post Share on other sites
hon0 10 Posted December 20, 2011 Circle with ball for cyclic and a simple slide bar for rudder could be sweet :) When you modify it appear and then fade 3 sec later. Good idea Share this post Link to post Share on other sites
zoog 18 Posted December 28, 2011 yes, I wanted to request this since the beta, but forgot about it. Like with black shark with this little red square showing all the current control input. Share this post Link to post Share on other sites
OMAC 254 Posted December 28, 2011 Circle with ball for cyclic and a simple slide bar for rudder could be sweet :)When you modify it appear and then fade 3 sec later. Good idea I was just thinking yesterday how a trim display would be nice. I second hon0's suggestion. Share this post Link to post Share on other sites
blakeace 11 Posted December 29, 2011 Not as nice as a built in trim indicator that you can position like the gps etc, but after reading this I thought of how much I would like this, so I created my own to use until an official one is developed. I thought I might as well share it too. http://forums.bistudio.com/showthread.php?p=2080654#post2080654 Share this post Link to post Share on other sites