seba1976 98 Posted July 31, 2010 I have a whole lot of missions from Arma that I'd like to run in Arma 2 but they are in Mapfact' South Sahrani. Does anybody was able to run that island in Arma 2? I've tried with CAA1 installed (default South Sahrani is working) but when launching the Mapfact version I get a CTD with no error msg. Please somebody help me! :) Note 1: I've searched as always but to my knowledge the topic has not been talked about. Note 2: I'm not sure if this is the right place to post this so I apologize if this is not. :D Share this post Link to post Share on other sites
Darkhorse 1-6 16 Posted July 31, 2010 Damnit, I thought Mapfact was going to go for one last addon, to "ride into the sunset" looking even better. Gawd-damnit. Oh, the place you missed, is a sticky on this section.... http://forums.bistudio.com/showthread.php?t=74362 Share this post Link to post Share on other sites
seba1976 98 Posted July 31, 2010 I've read that whole thread before I posted this. There are no references to the Mapfact island there. Share this post Link to post Share on other sites
enad 11 Posted July 31, 2010 Its the same thing. If you download CAA1 or get the listed pbos from Arma 1, then the Island will work. Share this post Link to post Share on other sites
seba1976 98 Posted July 31, 2010 I thought that too, but it didn't. CAA1 is properly installed and working, I've setup one of the missions to default South Sahrani (or "Saralite"), and the mission worked wonderfully in Arma 2 without me having to replace the units and weapons, so CAA1 is working. Also, the island get listed in the editor and there are no errors before or after I select it to open it, it just CTD so I don't know what else to try. Note: I forgot to tell, there was the common error of the 'requiere version 1.08', so I dePBO the island, change the number to 1.07, and PBOed it again. And after that no more errors. I don't think it has anything to do with that. Share this post Link to post Share on other sites
Darkhorse 1-6 16 Posted July 31, 2010 Either way, your asking for help converting an island from ArmA 1 to ArmA 2, which means you must use the sticky. Share this post Link to post Share on other sites
seba1976 98 Posted August 1, 2010 Either way, your asking for help converting an island from ArmA 1 to ArmA 2, which means you must use the sticky. Very helpful. Thanks. ---------- Post added at 09:02 PM ---------- Previous post was at 08:00 PM ---------- Success! It was just the 'required version' thing. The tool I used to dePBO and PBO again screwed something :mad:. I tried with a different PBO tool and it worked like a charm. Cheers. Share this post Link to post Share on other sites
