thy_raven 0 Posted May 3, 2008 I seem to have a problem with my map, i try to click on the heading on the notebook and the cursor shows the Red cursor for clicking on the map, and if i double click will place a marker on the map underneath the notepad instead of clicking on the notepad tab. The only way to click on the tabs is to click about 1/2 way down the notepad. it seems like the cursor is out of wack with the notepad or something because it works fine for placing markers on the map, just goes crazy for using the notepad. Have tried running villa arma and still the problem persists. the only thing i can think that might be causing it is I changed My FOV after installing 1.12 to get the old FOV back. but surely that shouldn't screw the map? Any help offered would be greatly appreciated Raven Share this post Link to post Share on other sites
malick 0 Posted May 7, 2008 I have a similar problem with the notepad that appeared in 1.12b: all clickable links and tabs are misplaced, I have to actually click to the bottom right to reach them. Example : to reach the Notes section in briefing, I have to click slightly to the right and below it in order to activate it (I can see the link getting highlighted/underscored). Link Position Cursor Position Same goes for all links on notepad. Any idea ? Malick Share this post Link to post Share on other sites
GLENNYBOY1 0 Posted May 7, 2008 Yup it's the FOV change. I tinkered with the 1.12 fov and like you say it puts the cursor 'out of whack' with the note pad and compass etc. Another forum member in the 1.12 troubleshooting thread pointed out this unfortunate side effect if you try to get the good old 1.08 fov back. Share this post Link to post Share on other sites
thy_raven 0 Posted May 7, 2008 is there a better way of changing the FOV rather than going into the arma profile thing?? bis must have had a way of doing it and not screwing the notbook when they changed it between 1.09 and 1.12 or is there a way of resetting the notbook FOV to match the new FOV??? Share this post Link to post Share on other sites
GLENNYBOY1 0 Posted May 7, 2008 As far as I've been told Raven the only option to change the fov is by changing those 2 fov values in the config profile. Maybe someone with more techy experience might have the answer to the notepad thing,I'd certainly like to know how to sort it too. GLENNY Share this post Link to post Share on other sites