pcpilot 0 Posted April 6, 2007 Ok, before everyone castrates me for not searching; I did! I cant seem to come up with a good search word for what I'm looking for and strings of words in a search just come back with 8 million results. Ive also went over a number of tutorials and referances and cant find my query either. What I am looking for is this...When I complete an objective, Id like a waypoint to then become visible to take me back to my base. I know this is simple and probably asked a hundred times but please bare with me. Thank you for your time. Share this post Link to post Share on other sites
kronzky 5 Posted April 6, 2007 There are different ways to go about it, but the easiest might be to synchronize a trigger of the type "Switch" with a waypoint. Once the condition for that trigger is fulfilled, the next waypoint will become active. Share this post Link to post Share on other sites
pcpilot 0 Posted April 8, 2007 Hmmmm, thanks for the reply. I took your advice and it doesnt seem to work. The first waypoint shows immediately, then switches to the next before Ive even done anything. Tried to sync from first the waypoint to the trigger. Then from the trigger to the waypoint just to see if there was a difference; there wasnt, it did the same thing regardless. So it still doesnt work yet. Share this post Link to post Share on other sites
kronzky 5 Posted April 8, 2007 Here you have two waypoints, with the first one being synchronised with a trigger. The trigger in this case is just a radio call, but could be anything. What is important though, is that it is of the type "Switch"! When you start the mission the active waypoint is the first one. Even if you walk towards it, and are standing on top of it, it will still just show "Wait". Once you activate the trigger though (via the radio) you will then see the second waypoint. Share this post Link to post Share on other sites
