jelly belly 0 Posted July 6, 2003 sup I have been using the tutorial by brsseb to set up my bulldozer but i get a strange message and suddenly i am in some sea area. I have done all of the troubleshooting that brsseb mentioned. any ideas. i have a g-force 4 card, if that helps. ohh and when i try and open the bulldozer seperatley it says "the countdown begins..." then takes me to the sea place. When i run O2 it just says "cannot run viewer." Share this post Link to post Share on other sites
franze 196 Posted July 7, 2003 You have a object loaded? It displays land/sea by default 'till you load a object. Theres a command to turn off the land and sea but I can't remember it off the top of my head. Share this post Link to post Share on other sites
blackdog~ 0 Posted July 7, 2003 Make sure you have buldozer in the root of a virtual drive Example: you have it in C:\ofpedit(\buldozer.exe) Use CMD (Start>Run>CMD) and type SUBST Z: C:\OFPEDIT Then, put in o2 for where Buldozer is, put Z:\buldozer.exe -noland -dx -window -noland -dx -window might be what you are looking for! Share this post Link to post Share on other sites
Hara Kiri 0 Posted July 7, 2003 Quote[/b] ]blackdog~ Evolution needed Group: Members Posts: 1662 Joined: Mar. 2002 Posted: July 07 2003,11:32 -------------------------------------------------------------------------------- Make sure you have buldozer in the root of a virtual drive Example: you have it in C:\ofpedit(\buldozer.exe) Use CMD (Start>Run>CMD) and type SUBST Z: C:\OFPEDIT Then, put in o2 for where Buldozer is, put Z:\buldozer.exe -noland -dx -window -noland -dx -window might be what you are looking for! -------------- and remember write all correctly! Share this post Link to post Share on other sites
