KingScuba 1 Posted August 25, 2017 So I'm trying to remap all of my controls, but I can't because arma registers a button being pushed at all times. Specifically, Saitek button #35, #34, and #33. any ideas? This also happens if ANY of my sliding type keys aren't dead center as well. Share this post Link to post Share on other sites
beno_83au 1369 Posted August 26, 2017 Might be a joystick issue. I got a X56 for DCS and two of the buttons were always on. Did some swapping out of parts with a mate and turned out it was all the joystick. You might need to consider exchanging it. Share this post Link to post Share on other sites
KingScuba 1 Posted August 26, 2017 Actually, after about 4 hours of putzing with it, I found out that the software CD I received with my joystick wasn't updating correctly. I had to go to the logitech site (I never knew logitech absorbed saitek. Go figure lol...) and download the new drivers and software, which fixed the issue I had. Now I can remap everything correctly without the game picking up my profile swapper. I had the same issue you did with some of my dials that weren't dead center. You can easily figure that out by going into the joystick settings and moving each one until you see the grey bar on the left go away (which indicates the button is activated), then setting the deadzone a little bit higher. Share this post Link to post Share on other sites
