Walkero0 15 Posted May 29, 2015 (edited) Hy. I ported the Arma 2 MTVR to Arma 3 and it's working fine, except the waterresistance. I can drive with full speed into water about 100 meters, then the engine die. I tried to add waterResistance value to the config, but this shows no effect. Is this a model or a config Problem? :confused: Edited May 29, 2015 by Lukeo0 Share this post Link to post Share on other sites
p1nga 23 Posted May 31, 2015 Hy. I ported the Arma 2 MTVR to Arma 3 and it's working fine, except the waterresistance. I can drive with full speed into water about 100 meters, then the engine die. I tried to add waterResistance value to the config, but this shows no effect. Is this a model or a config Problem? :confused: You need a Bouyancy LOD just the same as a boat, configure the maximum water level, which is the depth the water can rise before the engine is destroyed, water resistance value affects how difficult it is for the object to propel itself through the water. The Bouyancy LOD should really only be a single piece of geometry, closed and convex, in practice it does sometimes also need to be a certain amount larger than the actual vehicle, depending on the vehicle weight. Share this post Link to post Share on other sites
Walkero0 15 Posted June 15, 2015 Thx for your reply! Got it :bounce3: Share this post Link to post Share on other sites
