Mission not loading after 5+ changes

[Yolo Joe 11]

Hello all.

I've been updating my A3 mission a bunch lately, but recently I've run into some problems.

After placing 5 or more units in the mission, I am unable to load in to the mission. I'm stuck on 100% loading.

I have to place 2-3 units, save, preview, repeat.

This takes a lot of time when trying to populate a whole outpost...

I have noticed that custom units (with a loadout from the Virtual Arsenal) is less likely to work than the standard units.

As you can see, the objectives are very spread out.

http://i.imgur.com/VQtQ0AN.jpg (424 kB)

Right now, I seem to have reached the maximum amount(?) of objects placeable on the map...

I don't use any mods in the mission. Only scripts.

Here are the scripts I use:

BTC Revive

IgiLoad

TAW_VD

VAS

VVS

And some custom scripts with max 30 lines of code.

I hope to get some feedback relatively quick, as I want to update my mission for everyone to enjoy!

---------- Post added at 16:59 ---------- Previous post was at 15:23 ----------

And BTW, its not my PC specs.

8GB Ram

Intel i7 4770K @3.5GHz

GTX 780

[das attorney 858]

post your FULL rpt up in mission editing and ask nicely if someone can look through.

Also you can test some stuff as well.

Disable your scripts one at a time to see which one (if any) are responsible for error.

[Yolo Joe 11]

Not much help to get in /Editing and scripting either...

I'm still having the same problem where I now have to delete units to make place for new ones..

I have updated all of my scripts and deleted 3 of them. Any bright ideas?

[sttosin 67]

Try to start the mission, wait till it fails, copy your .rpt file for the session and paste here.