hdchristopher 11 Posted February 6, 2015 (edited) Jakerod has already mentioned setting your Projection FIRST - before you load the data - that basically tells GM "This project is in UTM Zone <whatever>, WGS84", so any data you subsequently load will automatically be reprojected to the "project coordinate system" - which is the correct UTM, etc (and all measurements will now be happening in Meters, which will come in handy just shortly... I have run into a problem,when I start GM and set projection to UTM, the bottom right corner tells me that my coordinate is out of range. Any file I load never appears. If I start GM, load file then set UTM it works fine, but not start GM set UTM then load file, nothing. Is there some settings that I need to make in the configurations panel? ****EDIT**** Never mind, figured it out.. DOH! :P Edited February 6, 2015 by hdchristopher Share this post Link to post Share on other sites
