Piraneous 10 Posted November 18, 2012 i keep reading that apparently this game supports the full range of motion in analogue throttle controllers like the one on my brand new HOTAS warthog. however this is not the case. when i try to assign the axis to the collective controls, it only ever appears in the assign key part after i've pushed the throttle past 50%. when tested in game play, the collective wont doesn't start being added till after 50% of throttle range and is maxed out at about 80% of the throttles range... i'm also trying to use the slider on my throttle to control the ingame throttle settings with no luck (seems there's no support for analogue throttles in game). what am i doing wrong? or are the rumors that this was fixed for TOH untrue? Share this post Link to post Share on other sites
EagleEye-GER- 0 Posted November 19, 2012 Make sure youre using the analogue throttle settings. I to have a Warthog. Will post my settings when at home. Share this post Link to post Share on other sites
Derbysieger 11 Posted November 21, 2012 (edited) What EagleEye said. However I have to say that I don't like to use the HOTAS Warthog in TOH because the centering force of the stick is just way too strong. As silly as it sounds - in TOH I get more precision out of my old shoddy Logitech Extreme 3d Pro because I don't have to fight the stick as much. Trimming helps a bit but that's more of a workaround than a solution. My recommendation would be to either use a cheap stick with a weak centering force or have a stick where you can remove the centering spring. Of course you can use the HOTAS Warthog but it's not really suitable for helicopters. Edited November 21, 2012 by Derbysieger Share this post Link to post Share on other sites
