ecahbra 1 Posted October 28, 2012 I have the Saitek X52 Pro and when I am in the engine startup training and I get to the roll the throttle to idle I press button 10 which is mapped to throttle decrease and I get the message wrong action. When I go to the setup and look at the mapping sometimes I see a random zoom out slider action when I press the button 10 or an autohover. Why am I getting "extra" controller inputs? Share this post Link to post Share on other sites
Sven2157 1 Posted October 29, 2012 Try updating your drivers: Saitek x52 Pro Driver Update You should get the SD6 Profile software as well. This installs the necessary drivers for the mouse( mini-stick ), so Windows sees it as a HID. Once the drivers are updated, make sure you calibrate ALL buttons and axes. Move the stick to the top left across the top to the top right; across the right to the bottom right, etc. Make a giant rectangle. Do this several times in a row, so the driver knows where the bounds of the stick are. Then do it for the throttle, and everything else; buttons too. Failing that, set your Dead zones a bit higher, try blowing the dust out of the stick with a can of air... Share this post Link to post Share on other sites
