HK (HunterKiller) 0 Posted June 12, 2002 Does anyone know if it is possible to choose all the cells on the map, so that i can lower an entire map in one go? ie ctrl and left mouse highlights red corners of the cells BUT to do this to the whole map at once would take a good day and ruin a good man hehe , I have a map that i converted from bitmap to ter and then through Wilbur into txt etc, but the whole map is above sea level, all the flat area around the island where the sea is is just sand texture, i lowered a small portion of the map by 20 metres and it showed water texture, therefore if i could lower the whole map it would be on it's way, ok thanks if anyone can help me Share this post Link to post Share on other sites
Hudson 0 Posted June 12, 2002 Choose Edit at top and then Select all cells or the key shortcut is Ctrl-Q ....Oops I just re-read your post and you need to hold Ctrl-Shift and then click a corner and drag the red box to the opposite side of editor Share this post Link to post Share on other sites
Vepr 0 Posted June 12, 2002 Is there a way to make elovation, Up/Down easier then Ctrl+Z and Ctrl+X? Share this post Link to post Share on other sites
IsthatyouJohnWayne 0 Posted June 12, 2002 what about the: 'Landscape' tab -choose operation- UP/DOWN ? enter figure Share this post Link to post Share on other sites
HK (HunterKiller) 0 Posted June 12, 2002 I owe you BIGTIME Hudson, thanks m8, it was getting me down, i had tried just about evrey other combination of keys lol. I even tried a marathon mouse clicking session, lasted 2 hours then nearly cried hehe. Share this post Link to post Share on other sites
