Angle 10 Posted July 1, 2011 Issue 1: Mirrors. When looking where the mirrors are on the model while standing outside all you see is a brown nothing. It would be nice if some glare or something was added to show that there is a mirror there. (The actual mirror would be nicer but i understand that there are issues with that.) Issue 2: Engine on/off when leaving helicopter. This issue appeared when i had been flying around Chernarus and decided to land and look at the copper from the outside for a while. I landed and got out of it without turning of the engine. And as soon as i got out the engine stared spooling down and eventually came to a full stop. But when i reentered the helicopter the engine was on fully just as i had left it and the rotors spinning. Share this post Link to post Share on other sites
Beagle 684 Posted July 1, 2011 1st Activate post processing and set it to normal for refelctions. 2nd Use "eject" on ground to get out not "get out". to keep engines running...works with all vehicles. Share this post Link to post Share on other sites
Angle 10 Posted July 1, 2011 (edited) 1st Activate post processing and set it to normal for refelctions.2nd Use "eject" on ground to get out not "get out". to keep engines running...works with all vehicles. 1st: Well i still think it looks quite gravelly and i turned it up to high. 2nd: LOL PNZORS L337!... Sorry had no better answer. Was i really that unclear about the issue? Edited July 1, 2011 by Angle Share this post Link to post Share on other sites
Beagle 684 Posted July 1, 2011 1st: Well i still think it looks quite gravelly and i turned it up to high.2nd: LOL PNZORS L337!... Sorry had no better answer. Was i really that unclear about the issue? Sorry but thats the way it works perfecrly for me... just use eject instead of get out... engine will continue to run until fuel is out. I can get in again and eject as often as I like and egine state is unchanged. Share this post Link to post Share on other sites
ryguy 10 Posted July 1, 2011 That's not what he means. He means that the engines appear to be turned off when you leave but when you enter you see the engines all spooled up as if they were on the whole time. Share this post Link to post Share on other sites
Beagle 684 Posted July 1, 2011 (edited) That's not what he means. He means that the engines appear to be turned off when you leave but when you enter you see the engines all spooled up as if they were on the whole time.O.K. I just noticed I answered in the wrong forum section. I was referring to A2. Edited July 1, 2011 by Beagle Share this post Link to post Share on other sites
