Suomileijona 10 Posted December 27, 2010 I would like to put tank wrecks in a town where i start. The problem is that i don't want to see them explode which happens when i put "set damage 1.0" or set their armor to 0. They should be already wrecks when i start the mission. Share this post Link to post Share on other sites
legion7698 0 Posted December 27, 2010 hey Suomileijona, As far as I'm aware, and anyone with more experiance can correct me if needed, there are only two ways to have wrecks at the start of a mission without the explosion. The first is to set the dammage to a certian point above fully damaged and set it to locked so no one can get in however be aware that even just above completly destroyed it can still explode so you'll have to experiment with the damage settings to get the desired effect. The other is through the of thrid party addons. Regards, LEGION7698. Share this post Link to post Share on other sites
rellikki 7 Posted December 27, 2010 You can avoid the exploding by reducing the vehicle's ammo and fuel too. While placing the tank in editor, move the Ammo and Fuel sliders to the far left to remove them. This should make it not explode when it gets destroyed. Share this post Link to post Share on other sites
Suomileijona 10 Posted December 27, 2010 Thank You! Share this post Link to post Share on other sites
legion7698 0 Posted December 27, 2010 I didn't know that Rellikki. I'll tuck that bit of info away for later use. Share this post Link to post Share on other sites
Aldo15 11 Posted January 8, 2011 (edited) I do not know that. You should write that in the notes. Regards to all:bounce3: ~Aldo Edited January 8, 2011 by Aldo15 Share this post Link to post Share on other sites
