duckmeister 10 Posted September 21, 2010 I have the game maxed out on a 5970 and Core i7 920 @3.5Ghz with Hyperthreading disabled. However, I notice that in OA, close-up textures that should normally be at their max detail are at a really low detail level. My graphics card isn't overheating, so what could be the cause of this? Any help is appreciated. Share this post Link to post Share on other sites
Modin84 10 Posted September 21, 2010 what drivers are you using? i had similar effects while using newer drivers, the ones that works for me are 10.4 Share this post Link to post Share on other sites
duckmeister 10 Posted September 21, 2010 10.8 with 10.8a application profiles. I was excited to learn that they've finally added Crossfire support for OA, so thats why I'm using these. Share this post Link to post Share on other sites
cabby77 0 Posted September 22, 2010 I have the same problem. It started with 10.8 drivers and continuing with 10.9s. This is with ATI 4870X2. If you stare the ground in front of you for a few seconds, the textures shift from low LOD to high. This also happens with soldier body and face textures. Share this post Link to post Share on other sites
Karhis 10 Posted September 22, 2010 Seems that the LOD (level of detail) switching is not working as intended with latest ATI drivers and particularly with Crossfire configurations. Many here have suggested to use 10.4 drivers to fix the problem - I haven't personally tried that. Maybe it is worth trying though - and you can temporarily enable the Crossfire functionality by renaming the "arma2oa.exe" to "arma2.exe". Other solution could be to install the 10.4 drivers and all the application profiles that have been released after that - dunno if that works though. Previous application profiles can be downloaded for example from here: http://www.rage3d.com/cap/ This seems more like a driver issue than an issue with the game, and since Arma2 isn't really that much of a "mainstream game", I'll doubt that ATI is going to fix it. But we'll see. Also remember to report the issue to AMD, using this form: http://www.amdsurveys.com/se.ashx?s=5A1E27D27E29B0E3 The more reports they get the more likely it is for the problem to get fixed in future driver revisions. The similiar problems are discussed also here: http://forums.bistudio.com/showthread.php?t=106543 Share this post Link to post Share on other sites
ProfTournesol 956 Posted September 24, 2010 I'm having an ATI HD4872x2 and 10.4 driver, and everyting's working nicely on high settings (apart PP set to low.). Catalyst AI enabled. One lesson though : never upgrade your drivers as long as you're satisfied with the one being installed. Share this post Link to post Share on other sites
