scifer 10 Posted August 4, 2010 (edited) I want to make three An-2T Colt planes, as a group, to land at Takistan airport ID 1, stop during taxing on the square in from of its two hangars, witch is out of the taxi way and wait until three civilian groups get on-board each plane to take off. I've done it synchronizing the planes' (not as a group) load waypoints with the civilians' (three groups) getin waypoints on the airport. But when the plane approaches the airport, the civilians begin to run across the landing strip and the plane only stops when it decelerate to a certain speed during a turn at taxing and not on a specific point. Is there a script or something to make a plane group to stop on a specific point in an airfield without the pilots leaving the airplanes? Edited November 24, 2010 by scifer Grammar Share this post Link to post Share on other sites
kylania 568 Posted August 4, 2010 Put a trigger where you want the plane to stop triggered by the plane and remove all it's fuel. Share this post Link to post Share on other sites
StarvinMarvin 0 Posted August 4, 2010 Im having a simillar problem but with a C-130 that i want to land on an airport and taxi to somewhere in front of the hangars but as soon as he touches ground he makes a INSANE brakein and turns straight of the runway and parks in the middle of the taxiway or close to it.. then the pilot jumps out... Another funny thing that i could mention on the same airport.. i have a chinook coming in with a group of soldiers.. they land and the soldiers exit then i have this group move via wp into a truck and then they are supposed to drive off to a nearby base. only problem is they all dissembark.. then the teamleader moves into the truck and drives of but the soldiers move back into the chopper... all i can say is ????????? and i scrapped that little part of the project.. anyone have any clues on why that happened?? Greetz // StarvinMarvin Share this post Link to post Share on other sites
kylania 568 Posted August 4, 2010 The problem is stuff around the plane. You can't have anything at all anywhere near the C-130 as it taxi's or else it'll try to avoid it, sometimes violently. This means that landing at the south airfield in Takistan for example you cannot have anything on the right side of the airfield at all, and in the main base, anything past the buildings will cause problems, even a guy walking there. Just keep removing things till the plane lands properly, or start it on the ground where you wanted it and skip the 3 minutes of landing/taxi'ing/trouble. Share this post Link to post Share on other sites
scifer 10 Posted August 9, 2010 Thanks every one. But I'm leaving the forum. Share this post Link to post Share on other sites
kylania 568 Posted August 10, 2010 Thanks every one. But I'm leaving the forum. :confused: Umm... bye? :j: Share this post Link to post Share on other sites
scifer 10 Posted November 24, 2010 Hi. I'm back :) ---------- Post added at 12:55 AM ---------- Previous post was at 12:07 AM ---------- As posted in http://forums.bistudio.com/showpost.php?p=1681744&postcount=3 it is possible to edit taxiways. Unfortunately it's not well explained. How can we edit vanilla airfields behaviors not only taxyways? I was thinking about putting a fork at ilsTaxiIn[] before hangars, so planes can park in front of them or keep ahead. Share this post Link to post Share on other sites
