Manual M119s and Editor Problems

[MH6 11]

How exactly can I get them to work? First of all, they have no ammunition (even after calling 'this addMagazine "ARTY_30Rnd_105mmHE_M119"'), and second of all the "Target Artillery" action does not work properly. It displays the map but not the artillery markers (red/blue crosses), and my players marker doesn't seem to rotate with the artillery piece (always facing north). This of course makes it useless.

On top of that my editor seems bugged. I fired off some Hydras and they did a 90-degree turn after launch and flew to a specific point on the map (they always flew to that point no matter what my chopper's rotation was). The MLRS rockets also did this...and if the MLRS happened to be between the missile tube exit points and that specific point on the map, it blew up (basically the missiles fired in reverse into the truck). And yes, I added the proper magazine to it beforehand.

I even tried to download premade missions from the Artillery Module thread and the artillery doesn't work with them either. I call in artillery and designate a target, the MLRS vehicles line up like their about to fire, the operators are calling out Shot over on the radio...but they never fire. Even after the operator calls out the splash notifications, they just sit there, rocket tubes pointed in the air, but never firing.

These problems only occur in the editor. In singleplayer/multiplayer, hydras fire straight as they're supposed to and artillery barrages actually fire. The "Target Artillery" option for the M119 works in multi too. I'm at a loss, and my wit's end. Any help would be appreciated.

Edit: It seems as if the Artillery Module is what causes the weird behavior of the MLRS/Hydras. Even if the MLRS isn't syncced with the ARTY module, once I place one the MLRS rockets go from shooting straight and proper to blowing up the vehicle.

Edited July 4, 2009 by MH6