Break/Tail Lights show as black

[BennyBoy 0]

I can't for the life of me figure out why my tail light transparent areas show as black, they are using the correct textures and rvmats as far as I can tell:

ca\wheeled\data\cessna_redlight.tga

&

ca\data\data\default_flash_2pass.rvmat

Any tips would be really appreciated as this is holding up the release of nice little toy :D

[Planck 1]

Try selecting the relevant faces and re-ordering the faces using the Faces Menu ... Move top ... Move bottom ... etc.

Planck

[BennyBoy 0]

Will give it a try, thanks.

---------- Post added at 06:22 PM ---------- Previous post was at 06:06 PM ----------

Well, that changes the display order but they still have a black fill where the transparency should be :/

[Planck 1]

Well I know I had this at one time, wish I could remember how I fixed it exactly. :confused:

Planck

[BennyBoy 0]

OK, managed to sort this out - I extracted the rvmat and placed it in the correct path in P: - it looks like binpbo actually needs to read the rvmat in to make the lights work correctly. I had just figured that it would read it in when the engine started and that it wasnt required when binarising.

[granQ 293]

thanks had this problem as well, think had the right paths for the rvmat but will check later.

[rstratton 0]

OK, managed to sort this out - I extracted the rvmat and placed it in the correct path in P: - it looks like binpbo actually needs to read the rvmat in to make the lights work correctly. I had just figured that it would read it in when the engine started and that it wasnt required when binarising.

tried it, didnt work