A10's just want fly in the height i want

[uddercream 1]

ok i have an a10 flying and i type in this flyinheight 30 and it still flys in the default height , i also put it in a trigger and a waypoing and nothing happens and i know i am typing it right because if i change it to a chopper it will do what i ask. thx

[mahuja 12]

The pilot inside the a10 isn't suicidal enough to fly at 30 meters. And there is no way of setting how suicidal a man is.

[mahuja 12]

Besides, even if you could make him fly at 30 meters, he wouldn't be able to do anything useful. Esp. not after getting to know the ground a bit better. (which is inevitable unless this command is only used for flight over water.)

[Rob 1]

and even the ai wouldn't be able to control an aircraft flying at 600+ mph

[uddercream 1]

you can control the a10 at that height and what i was talking about is when he reaches a waypoint then he will drive quickly like in real life with the a10 going after a target , how do you think they use there gun , its by diving very quickly almost straight down ya get my point?

[Starsky 0]

The command "flyinheight" only works with choppers as stated in the official command reference guide from BIS.

[Khamul 0]

Agree With Repply just up.

For your problem the only solution is a SetPos Script

[InqWiper 0]

I think a looped setpos would just look real stupid.

[Admiral_Petrarch 0]

I just can't get flyinheight to work with anything, and I've followed the instructions in Abuu's tutorial to the letter.

[Guest SC Jolly]

The AI refuses to accept a flyinheight too low. *Cough, patchcough*. AND: I'm sure I'm not the only who loves dogfights, but it cannot be done in OFP, coz the ground disappears and everyhing looks BLAUEH! What is the command for setview? is it "setview = 4000" or something???

And how do I get the AI planes to attack me? they travel like two miles away before engaging.