Jump to content

Recommended Posts

OK, there was two simple errors in the config. Corrected parts:

 

RYD_HAS_STT = //names of the units to be transported
	[
	unit1,
	unit2,
	unit3,
	unit4
	];

(there should be no comma after last array element)

 

RYD_HAS_DoorsToOpen = //optional setting of animation sources, that should be animated before deploying fast ropes - intended for doors. Leave empty for no animations
	[
	//[heli1,["Door_Back_R","Door_Back_L"]]//Mohawk
	[heli1,["door_l","door_r"]]//Ghosthawk
	//[heli2,["door_l","door_r"]]//Ghosthawk
	//[heli1,["Door_rear_source"]]//Huron
	];

(heli2 line disabled, therefore comma at heli 1 line removed)

 

After these changes I see no more errors at init. 

  • Like 2

Share this post


Link to post
Share on other sites

I've made the adjustments. The last error went but it was replaced by a new one...
 

https://ibb.co/mtpdnzZ

 

I get on both my modded and vanila verison of the mission.

 

 

Share this post


Link to post
Share on other sites

I saw it before, but no more after mentioned corrections. Here's your demo after those corrections. When I run it, there's no any error logs, HAS seem to init fine:

 

https://www.dropbox.com/s/r77fuq6tce9z11v/Long%20Rangevanilla.Stratis.zip?dl=0

 

One really need to be careful and avoid any syntax errors and typos. 

Share this post


Link to post
Share on other sites

I must of missed something......again....At least it works haha!

Thank you very much! Soooo happy it works now! I've been pulling hair out about this for ages!

Thank you for your help and time. it is much appreciated!

  • Like 2

Share this post


Link to post
Share on other sites

Meanwhile...

 

HAS 1.96wip1

 

For a try integrated this stuff:

 

 

There will be an option to make heli to fly in this manner except from slingloaded cargo delivery. In order to use it, keep in userConfig.sqf this true:

 

RYD_HAS_ContourFlightMode = true;//if enabled, new, lowest flight ceiling is added: "contour flight", where heli will try to fly as low, as possible.

 

and when ceiling change is possible at HAS call pending, set for the heli ceiling below usual minimum (for example use -250m when at default ceiling). It should be possible to switch back and forth on the fly, I hope.

 

I tested this a bit, but of course there's an ocean of circumstancies nad factors combinations to check out in order to be sure, CFS dances elegantly enough with HAS. Also CFS itself is still under testing...  

  • Like 3

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

×