canadian1337 17 Posted January 9, 2018 As in the title. You've probably seen this kind of thread multiple times. I'm trying to create an infantry paradrop on IFA3. The only problem I'm dealing with at this point are AI pilots changing height very rapidly due to the landform. Things I tried:https://community.bistudio.com/wiki/flyInHeightASLhttps://community.bistudio.com/wiki/flyInHeight Share this post Link to post Share on other sites
mrcurry 470 Posted January 9, 2018 Now I haven't tested this but from my understanding: flyInHeight = minimum height above terrain flyInHeightASL = minimum height above sea-level To get what you are describing I recommend trying flyInHeight = minimum height to fly at without colliding ground obstacles, around 15-50m be good i think. flyInHeightASL = your flying height + approximate terrain height above sea level The key is to set flyInHeight low enough so that: terrainHeightASL + flyInHeight < flyInHeightASL Share this post Link to post Share on other sites
canadian1337 17 Posted January 9, 2018 Forgot to mention that they succesfully fly at defined hight but as soon as the plane reaches a hill it will start gaining altitude. Share this post Link to post Share on other sites
mrcurry 470 Posted January 9, 2018 I edited my reply as you posted incase you missed it. Just to clarify: If the hill the plane is flying over is 60 m ASL and the plane is supposed to fly at 100m ASL you set flyInHeight to <40m and flyInHeightASL to 100m If in doubt set flyInHeight to 0 and flyInHeightASL to 100. Just make sure there are no obstacles in the flight path at 100m ASL Share this post Link to post Share on other sites
canadian1337 17 Posted January 9, 2018 Ah, ok. Gonna check it and post the result. Thanks. Share this post Link to post Share on other sites
canadian1337 17 Posted January 9, 2018 So I tried few different set ups and sadly the problem is still there :/. The plane does 2 strange "bounces" (nose up, 5 sec break, nose down) like if it was adjusting to the terrain below. Share this post Link to post Share on other sites
johnnyboy 3741 Posted January 9, 2018 My JBOY Fly in Formation script can probably help. This script moves objects across the sky in formation, at a single height ignoring the terrain ups and downs (see the video in the link...first it shows birds flying, then jets). Note the planes may have no AI while doing this. But if you only need the planes to drop paratroopers and fly away then it would work fine. The script works by creating a single object (_birdLeader) that will be moved through the sky using setVelocity. If the parameter of "birdCount" is greater than one, additional birds are created and attached to the _birdLeader. Since they are attached they move in exact relative position with the leader. I believe this can be modified to meet your paradrop needs by one of these methods: Modify the script to simulate the paradrop by adding and ejecting the units from the aircraft createVehicled in the script...or... Modify the script to accept an array of editor placed aircraft that have your paratroopers on board (and remove the createVehicle code from the script). Good luck! 2 Share this post Link to post Share on other sites
canadian1337 17 Posted January 9, 2018 Gonna give it a try. Don't need to modify it since the paradrop will consist of players, not AI. Thanks! 1 Share this post Link to post Share on other sites