ll Mysterio ll 0 Posted August 8, 2015 I have put my object into arma 3 successfully ,but you can walk straight through it. Share this post Link to post Share on other sites
burritoman259 10 Posted August 9, 2015 I have put my object into arma 3 successfully ,but you can walk straight through it. Have you made a geometry lod? you need one for collision detection ingame. https://community.bistudio.com/wiki/LOD#Geometry https://forums.bistudio.com/forum/165-arma-3-modelling-o2/ This should cover it, the second link has an example of geometry by Pufu. Share this post Link to post Share on other sites
NerdSam 1 Posted August 14, 2015 I have put my object into arma 3 successfully ,but you can walk straight through it. If a geometry LOD is in place and you can still phase through: alter the mass of the named selections/vertex groups within object builder, and then save. Pack it up and that ought to solve it. Share this post Link to post Share on other sites
x3rv1th 10 Posted August 23, 2015 Don't forget about naming.... in geometry/physX LOD you should use componentX eg. component1,component2,etc. Otherwise you will be able to pass through object. I had a lot of problems with it as well before I figured that out. Share this post Link to post Share on other sites
ievel 0 Posted March 7, 2016 Don't forget about naming.... in geometry/physX LOD you should use componentX eg. component1,component2,etc. Otherwise you will be able to pass through object. I had a lot of problems with it as well before I figured that out. How do I change the name to component1? EDIT: nevermind got it Share this post Link to post Share on other sites
TeTeT 1520 Posted March 7, 2016 How do I change the name to component1? Right click on the selection and rename. Be sure to do that on the geometry lod and not somewhere else... Share this post Link to post Share on other sites
