Why do some objects show up in the external

[unclepogy 0]

Hello -- I did a search on this one... I have imported some of my 3D Max model files into O2 and they load ok. I am able to apply textures to some of them and they can be viewed in Bulldozer. But when I load some of the other imported files, (which have been saved as p3d's too), and try to view them in Bulldozer -- they don't show up. Additionally, sometimes there is a grey cube that shows up in the viewer that can be zoomed in, just before Bulldozer crashes. I checked the files sizes and that's not it. I've followed all the recommended O2, and viewer installation instructions... Does anyone have any ideas? Thanks Uncle

[unclepogy 0]

Is there any logic to where we place the 3d objects in regards to the Grid -- so that they show up in the external viewer? Thanks Uncle

[VXR 9]

i also had that problem once

somtimes its fixed by pressing a few times alt-tab

otherwise i dont know whats wrong with it maybe something with the model

[PakoAry 0]

since I've just installed the prog and I'm reading the forum before I start prospecting it, I cannot provide you with an answer and so, instead, I'll question: have you checked the normals orientation?

good luck

té mais

PakoAry