ArmAriffic 10 Posted June 19, 2011 (edited) Following this tutorial and i'm up to step 9 in editing #Step 9: Okay, now you would probably want to view your terrain in the engine, if you go to Project--> Connect to Buldozer you should start up Buldozer (there might be some problems here, but for me it worked without problems from the start as far as I can remember). If it works you should now be floating around in the air above your untextured terrain, to move around use your mouse and numpad keys. If you don't like the setup you can press F1 in Buldozer mode to change GFX settings and Buldozer navigation. You can also run buldozer in windowed mode (see BIKI) but I just navigate between V3 and Bul with Alt+tabbing. It loads for about a second then crashes, did I forget to do something? Edited June 19, 2011 by ArmAriffic Share this post Link to post Share on other sites
[aps]gnat 28 Posted June 19, 2011 Not really enough info - Step 9 in which section ? "editing" doesnt help - Its an ArmA tut, not ArmA2 "tuned" - No idea what your source data is - whats in your V3 options for the Buldozer startup? - WHich version of the tools are u using Share this post Link to post Share on other sites
ArmAriffic 10 Posted June 19, 2011 (edited) nevermind it was searching for buldozer in the wrong drive, problem solved Edited June 19, 2011 by ArmAriffic Share this post Link to post Share on other sites
